When is a datum reference used?
When marking out
When cutting out
When joining pieces
What is the practice of fitting together shapes without any gaps called?
Nesting
Tessellating
Lay planning
Which of these is used to mark out textiles products?
Pattern
Jig
Reference points
What angle is an engineer's square used to measure?
45 degrees
135 degrees
90 degrees
Which tool is used to score and cut paper and card?
Craft knife
Compass
Scriber
What is the practice of fitting together irregular shapes as close together as possible?
How do you find the volume of a prism?
Area of the cross section ÷ length
Area of the cross section x length
Length ÷ area of the cross section
What is used to mark out a circle?
Mortise gauge
Sliding bevel
What is a datum reference?
An orthographic drawing
A template
A reference point that all measurements are taken from
How is the volume of a product calculated?
Volume is calculated as length x width x height
Measuring the surfaces and adding them together
Measuring a working drawing